Designed some new ear pieces in Illustrator to replace the old ones, to be cut in aluminium
View attachment 190235
Less than a week later I had these
View attachment 190236
They are cut using a water jet, so the edges are a little rough, but easy to tidy up.
View attachment 190237
Spent an hour or 2 sanding and polishing whilst watching Netflix. I used a countersinking drill bit on the holes to allow screws to sit flush where they need to. I also tapped some of the holes. Ended up widening the movement slot so a wider screw could fit through and thread into the guide hole on the range finder
Assembly test fitting
View attachment 190238
The ear cap will go on with 2 magnets which are then recessed in the 2 holes
View attachment 190239
I had a few sets of these made, I'll post in the Cargo Hold what I have