TheFiveO
New Hunter
I've seen so many amazing builds on here I have decided to dive in. I have some basic building skills and plan to learn as I go. Hopefully some of the other novice builders on here can learn with me.
Here we go!
The photos above are of the basic layout for the top and bottom of the cabinet. I got the measurements from the blueprints that have been posted on here before.
This is the cutout for the top and bottom of the cabinet. I am using 3/4 MDF for the outside of the box hoping to make it sturdy.
I used 1/2” press board for the top panel.
I created these mounts for the inside to hold the panels at the right angle. I also measured them out so they lay 1/2 below the top so the Han board will have some extra support on the sides.
Thought I’d post the plan in case someone didn’t have them yet. I did not make these and found them on TDH.
Here we go!
The photos above are of the basic layout for the top and bottom of the cabinet. I got the measurements from the blueprints that have been posted on here before.
This is the cutout for the top and bottom of the cabinet. I am using 3/4 MDF for the outside of the box hoping to make it sturdy.
I used 1/2” press board for the top panel.
I created these mounts for the inside to hold the panels at the right angle. I also measured them out so they lay 1/2 below the top so the Han board will have some extra support on the sides.
Thought I’d post the plan in case someone didn’t have them yet. I did not make these and found them on TDH.
Last edited: