I am having some printing issues. I printed the dome with no problem. But when I try to print out the rest of the helmet parts, none of them fit to page. The printing starts about an inch lower than it should and no matter what setting I use to print, I get the same darn thing. Can anyone gimme a hand?
It depends which file you downloaded. This file ==> http://home.comcast.net/~wizardofflight/BobA_Fett_Helmet_Templates_Std.pdf is in Letter format (it is located in the middle section of the first post) while this ==> http://www.thedentedhelmet.com/atta...s-bf-helmet-templates-a4.pdf-21807d1198003510 is in A4 format (at the end of the first post).
I hope it helps!
i'm having a bit of an issue with the painting templates. what's the best way to resize them? printed outright, the back panels are a bit too tall and about a half inch too narrow.
ah! I see. I'm using the ones from the zip file. I see the others now. I'll give them a shot. do you have a recommendation on which templates I should use for the rest of the sgtfang?
The SGT Fang helmet is one of the mystery helmets, so the rest of the stencils should fit pretty well (with slight re-sizing, especially the left side). Use the images from the ZIP files or the PDF files, but for the back plates use the ZIP files located above the cheek stencils.