Building a Jig for the Jetpack Harness

Thread starter Soundwave
Start date Nov 15, 2017

Soundwave

Hunter

Jan 28, 2018

ShortFuse said:
Pipe bender would work excellent, especially with the conduit. I had good luck with bending it by hand over a landscape timber set in a vise. A coworker has a pipe bender and that was going to be my next option, if I was unsuccessful with my first try.

I haven’t had much luck finding the right size of pipe bender. Each bender I’ve found costs about the same as a harness kit itself. I did try a conduit bender, but you can only get about a 90 degree bend. The radius of the bend ended up being too wide.

This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.