Putting together a jetpack

Unlimitedfett

New Hunter
Can anyone give me some guidance on how to put together a sith planet boba fett jet pack. I have tried liquid nails and a heavy epoxy but to my dismay it comes apart. If there is a glue out there I sure would like to find it and build my jet pack. Thx again.
 
I’m no expert but have you tried Gorilla glue or E6000?
There may be better options but those are just a suggestion.
 
May also help if you let us know what materials you are using, some glues work better than others depending on material.
 
Here is a picture of the jet pack.

C9DA2276-3EAE-4B5C-B067-EB8FFF0424D0.jpeg
 
First..have you washed it? Use some degreaser and let the jetpack soak and dry for over 24 hours.

Then I would use jb weld two part epoxy and let it set for the full cure time.
 
No I did not do that. That is something that I will do. Okay then I will use JB weld epoxy. Thank you again. I really appreciate your help!
 
If you are going to use the 5 min JB Weld, make sure you mix up in small batches at a time. There's always something that doesn't go together like you planned it to and
If you mix up a big batch, it's easy to run out of time and waste the epoxy...
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top