Need Advice on a Captain Rex Helmet

Thread starter Kevin1701
Start date Dec 18, 2020

Kevin1701

New Hunter

Dec 18, 2020

I bought a Phase II Captain Rex helmet from a seller on Etsy for my son. The helmet looks very well made and is actually built around a heavy duty bicycle or motorcycle helmet. There's plenty of padding as well as lights (making this the only helmet I could find with lights). The only problem is that it uses the lens from the motorcycle helmet, which doesn't extend to the bottom of the "T. I found a replacement T-shaped clone-trooper lens on-line and I'm hoping it will fit, but I'm not sure how to adhere it to the interior of the helmet. It has padding all around. Foam-board friendly construction adhesive? Here are some photos of the helmet. The new lens should be here in a day or two, and I'm bucking the Christmas deadline so I need to get it right the first time. Any help would be greatly appreciated.

This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.