DarkSaber 3D Print

Thread starter GG3D
Start date Apr 15, 2023
Tags

darksaber lightsaber mandalorian mandalorian props starwars

GG3D

New Hunter

Apr 15, 2023

Man this site has changed a lot! I have been away since 2010... and Finally getting back into a serious passion I once had.

I recently got my self a 3D printer, And figured I'd test it out by modeling out the Darksaber and starting my collection. Still trying to figure out those settings some imperfections on my prints for sure.

Here are some progress pics and a shot comparing the size to my old school Vader lightsaber.

Looking forward to you thoughts !

Thanks.

This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.