Vibroblade finished

Thread starter Whistlingbird
Start date Feb 10, 2023

Whistlingbird

Hunter

Feb 10, 2023

Just finished my vibroblade, used toothpaste to keep the rub n buff from being painted over on the handle, then spayed handle with prime gray with a slight blue hue, after drying washed off the handle with warm water and cloth which removed the toothpaste and revealing the results as you see above. I got the complete vibroblade through Etsy for around 19 dollars, it was jet black when I received it, I hollowed out the center length of the blade with a drimel tool to make it look more realistic. Not too bad for the price!

This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.