Newly casted and finished ROTJ gauntlets

James the fett

New Hunter
20170718_192647.jpg
20170718_192623.jpg
IMG_20170718_185420.jpg
IMG_20170718_185443.jpg
20170718_192241.jpg
20170718_192328.jpg
20170718_192701.jpg
20170718_192304.jpg
Hello! These are my Return of the Jedi Boba fett gauntlets. Cast from resin and reinforced with fiberglass. Wired with electronics to light up flamethrower nozzles and red light on left gauntlet. Darts on a right gauntlet are 3D printed stainless steel. Everything else is cast resin molded and sculpted by me. Painted in three layers of rattle can and airbrushing then finished by airbrushing black details. Did my best to make these as accurate as possible. Just posting to share my work and maybe get some tips. Thanks for looking and May the force be with you!
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top