My ROTJ Boba Fett build

jthornton1993

Jr Hunter
Figured I'd post my build thus far since I've been stalking these forums for quite sometime. :p
Paints used: Helmet is currently all Humbrol Paints, Armor is being painted with all Rustoleum rattle cans.

Parts list

Helmet: Animefan
All the armor: Woodman
Jumpsuit, vest, neck seal, ankle splats and pockets: Arkady
Jetpack: MoW

Soon to get parts

Gauntlets: RKD
Helmet servo and RF light kit: jc27
Chest light: Fettronics


13329615_10206838459780055_3554500288560529407_o.jpg



13528377_10207078314776280_3325063751892933644_o.jpg



Going to be working on the dome next :D
13522901_10207046660624946_3983533020016374005_o.jpg


Will be painting the emblem on next as well as weathering :)

13508928_10207065508376128_8992388593359692008_n.jpg


Went a little overboard on the weathering here, but I actually ended up liking it :)

13482927_10206973160947500_3799455460953335777_o.jpg
 
Thanks folks! Finished the weathering last night on the chest and ab plate and even managed to figure out how to make the blaster bolt ricochet effect on the plate on the right. (which is the left chest plate to the wearer)

13559210_10207097104126002_2432676841015528298_o.jpg
 
Last edited by a moderator:
Repainted the green on the back panel because I wasn't satisfied with the Humbrol 76 and 131 green mix...Repainted the green with Tamiya XF-70 and Humbrol 131 mix.
13654413_10207236440569326_1575226121950931171_n.jpg
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top