My Own Sabine Rebels Mando Helmet WIP - I hate mandibles

shenphong

Active Hunter
Thought I'd share some shots of my sabine helmet, almost there...
yTqAK2mh.jpg

X8wGtYNh.jpg

H5DfBYqh.jpg

XsozpxJh.jpg

xhZnzpMh.jpg

dU3lpt9h.jpg
 
This also looks like a very nice start. I'm a little concerned with the width of the keyslot area. Sabine has a narrower than normal keyslot area vs other Mandos (including the Death Watch). It will be much easier to fix now at the priming and filling stage...!
 
It might be the camera angle but its definitely not as large looking in person, but yes thanks for the advice! I'll thin it out should need be, rather than printing a whole new bucket, it'll be a lot easier to fill it in beforehand
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top