Shin Tools JP Adjustment Tool

Does anyone know where I can acquire a JP adjustment tool for my ROTJ shin set? I would prefer metal over 3D printing, if at all possible. Everyone I have contacted up until this point do not have any currently in production.

- Mike
 
Now for the hijack.....
does anyone ale them for the ESB fett fellas? Looking for aluminum one, as was the OP here. Mojo-fett do these anymore?
 
I have a piece of aluminum pipe that I could send you, syllander if you pay for the shipping. I got it from online metals.
 
PM replied! I'll ship it Monday.

**edit** For anyone else interested, here is the link to where I got mine:

https://www.onlinemetals.com/merchant.cfm?pid=1213&step=4&showunits=inches&id=71&top_cat=60

The photo at the top of the site is just a generic tub photo, not what you'll get. Here is a photo of the actual tube:

https://www.flickr.com/photos/bryanc53/16122966495/
IMG_2337.jpg
 
Last edited by a moderator:
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top