Jabba throne for My Boba Fett throne

MAULFETT

MAULFETT

Active Hunter
Hi, it have been a while, very busy with personal situation, here are some photos of The jabba throne, already made The six gargoyles and with old Woods and PVC panel i start The frame of The throne.
 

Attachments

  • 17004043426215348833705848108900.jpg
    17004043426215348833705848108900.jpg
    1.8 MB · Views: 52
  • 17004043846648223078568254265149.jpg
    17004043846648223078568254265149.jpg
    2.1 MB · Views: 48
  • 17004044062153776707572792543481.jpg
    17004044062153776707572792543481.jpg
    2 MB · Views: 47
This thread is more than 5 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

MAULFETT
My Boba fett throne from Puerto Rico
Replies
3
Views
498
robotzo
robotzo
MAULFETT
Boba Fett throne
Replies
4
Views
1,365
MAULFETT
MAULFETT
MAULFETT
Rancor Head for the Boba Fett throne
Replies
0
Views
990
MAULFETT
MAULFETT
Badjudget
Coating for my Helmet?
Replies
1
Views
1,344
Rook 3
Rook 3
Rook 3
Q: Best filament for helmet/armor printing?
Replies
0
Views
923
Rook 3
Rook 3

Similar threads

MAULFETT
My Boba fett throne from Puerto Rico
Replies
3
Views
498
robotzo
robotzo
MAULFETT
Boba Fett throne
Replies
4
Views
1,365
MAULFETT
MAULFETT
MAULFETT
Rancor Head for the Boba Fett throne
Replies
0
Views
990
MAULFETT
MAULFETT
Badjudget
Coating for my Helmet?
Replies
1
Views
1,344
Rook 3
Rook 3
Rook 3
Q: Best filament for helmet/armor printing?
Replies
0
Views
923
Rook 3
Rook 3
Back
Top