Han Solo DL-44 Blaster.

bobamaker

Active Hunter
Here's my attempt at Han Solo's ANH Hero DL-44 with unique 'Floating Display Stand'. I drew this digitally, then broke it down into more than 30 sections ready for hi resolution 3D printing. Once all the parts were printed, they were all moulded using mainly compression moulds. This was quite labour intensive but the only way to get the quality. This finished blaster is cast in resin and the base is fibreglass.

In-Hand.jpg

Left+Stand.jpg
Right+Stand.jpg
Details.jpg
 
0F2D7E4F-AAC1-47E7-A507-17EB1BA3E2D9.jpeg
Sheer artistry. I own an air soft pistol replica of the DL44 displayed at this time. I don’t think I would be able to troop with it though. Do you sell this beautiful piece?
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top