Backplate jetpack attachment Help!

Dbop

New Hunter
So I screwed in these tabs for a better hold, but then it doesn't fit (attach) to the jetpack. Yet, if I take out the screws the glue doesn't hold and the tabs fall off when I do attach the jetpack. Any suggestions?

PXL_20221030_173346704~2.jpg
 
So I screwed in these tabs for a better hold, but then it doesn't fit (attach) to the jetpack. Yet, if I take out the screws the glue doesn't hold and the tabs fall off when I do attach the jetpack. Any suggestions?

View attachment 231813
From what I can tell from the picture and if I understand you correctly, it looks as though the screws need to be countersunk more so that they are flush to allow enough room for them to attach to the jetpack.
 
This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top