Hyperdyne rangefiner LEDs

killerkeith

New Hunter
I bought an LED system from Hyperdyne and it doesn't even come close to fitting into the housing. I have the standard model that comes with any FP, GMH, or Animefan kits, and the LEDs are almost an inch thick from the top of the battery to the under side that has the tilt switch.
Has anyone got a solution, besides making any own custom housing? This damn thing wasn't cheap and you would think if the maker was clever enough to make these he would have been clever enough to make them fit.
 
Do you have pics? I haven't seen a hyperdyne kit in forever.
 
Hi Jc26
Yrs, here are a couple of pics showing how the system is too thick to be housed by the rangefinder. Even if I could ram it in, the clear part still has no room.
I am cautious or damaging the thing at the price I paid for it.

20170921_070503.jpg


20170921_070445.jpg
 
Hey Jc26
I understand you make and sell the LEDs? If so, can you send me a pic and a price? I am now in the market for a decent system as this turd didn't work out.
 
Last edited:
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top