Boots Crookknight's ESB 3D Pack Design and Prototype

Thread starter sakurasanta86
Start date Jun 1, 2018

sakurasanta86

New Hunter

Jun 1, 2018

I have been working on the design for a couple of months. Going for the ESB Boba Fett Jetpack. I took this one to see if we could come up with a lightweight, durable, and cost effective alternative. All parts are 3D printed ABS and hollow. Once I have the pack assembled, I will weigh it, but it should be less than 10 lbs. Thinking it might be around 5 lbs. Since we are 3D printing we are able to increase the level of detail. I had been posting the progress on BHG, but was told I could get better feedback on this site. Plus, I will be building a ESB Boba Fett, myself. The next trick is going to be painting and weathering. Below are some of the 3D renderings and some of the parts that have just arrived.

This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.