Boba RotJ Right Gauntlet

Thread starter CptHellcat
Start date Sep 15, 2017

CptHellcat

New Hunter

Sep 15, 2017

Hi, I have a question on 2 parts of Boba's right gauntlet. I got a kit years ago and am finally working on assembling them. There are a few details missing from the sculpt.

What can I use for the black rectangular piece (with slightly rounded edges) that is on the top of the gauntlet near the triangular hose input? Is there a part I can use or would this have to be molded?
Same thing for the small tube that extends above the darts? It looks like either a cylindrical metal tube or it may be slightly conical?

This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.